[Ansteorra] Combat Bolts
james at crouchet.com
Tue Dec 21 11:09:26 PST 2010
So are you saying we should make the hole BEFORE shoving the
fiberglass shaft into the APD? Just asking because the Northstar
instructions say to do it after and then only if it bulges. You way
sounds easier though.
On Fri, Dec 17, 2010 at 7:00 PM, John <iaenmor at swbell.net> wrote:
> Take a heated pin or very small drill bit and make a hole thru the side of
> the APD at the bottom (near the nock). This will allow extra glue to squirt
> out. It helps. Use a small rod or something like to figure out were the
> end of the shaft hole is.
More information about the Ansteorra