[Ansteorra] Combat Bolts

[James Crouchet]

So are you saying we should make the hole BEFORE shoving the
fiberglass shaft into the APD? Just asking because the Northstar
instructions say to do it after and then only if it bulges. You way
sounds easier though.

Christian Doré

On Fri, Dec 17, 2010 at 7:00 PM, John <iaenmor at swbell.net> wrote:
[snip]
> Take a heated pin or very small drill bit and make a hole thru the side of
> the APD at the bottom (near the nock).  This will allow extra glue to squirt
> out.  It helps.  Use a small rod or something like to figure out were the
> end of the shaft hole is.