[Ansteorra] Combat Bolts

[Paul Thorne]

Yes before, it allows the glue to fill in better.  With COSSs cache of well
over 2000 pieces of ammo there has been an enormous amount of data
discovered on the best way to assemble these.

-JP DeCalmont
Company of Saint Sebastian



On Tue, Dec 21, 2010 at 1:09 PM, James Crouchet <james at crouchet.com> wrote:

> So are you saying we should make the hole BEFORE shoving the
> fiberglass shaft into the APD? Just asking because the Northstar
> instructions say to do it after and then only if it bulges. You way
> sounds easier though.
>
> Christian Doré
>
> On Fri, Dec 17, 2010 at 7:00 PM, John <iaenmor at swbell.net> wrote:
> [snip]
> > Take a heated pin or very small drill bit and make a hole thru the side
> of
> > the APD at the bottom (near the nock).  This will allow extra glue to
> squirt
> > out.  It helps.  Use a small rod or something like to figure out were the
> > end of the shaft hole is.
> _______________________________________________
> Ansteorra mailing list
> Ansteorra at lists.ansteorra.org
> In order to make changes and manage your account please go to:
> http://lists.ansteorra.org/listinfo.cgi/ansteorra-ansteorra.org
>