<!DOCTYPE html PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN">
<html>
<head>
  <meta content="text/html;charset=windows-1252"
 http-equiv="Content-Type">
  <title></title>
</head>
<body bgcolor="#ffffff" text="#000000">
Ya that obviously needs some work.<br>
<br>
Mike wrote:
<blockquote cite="mid4502DC6A.4020305@netzero.net" type="cite">
  <pre wrap="">Heilsa,

Continuing review the draft of the Missile Weapon Section to the 
Ansteorra Marshal's Handbook have another question.

I have built and shot golf tube arrows at Lillies Wars and the build 
instructions I was working with were clear needed to make a cut in each 
Tennis ball tipped golf tube along the same length as the Sling Stones. 
Yes, the Tennis balls were secure to the golf tubes, but these arrows 
still moved when someone stepped on them, especially the ball portion.

In Section III. ARROWS, BOLTS AND OTHER MISCELLANEOUS MISSILE WEAPONS
<snip>
B. Siloflex Tube Arrows/Bolts:

<snip>
3. Shall have combat blunts that meet all Society standards of the 
following type and restrictions:
a. Tennis ball securely attached to the end. A minimum of reinforced 
fiber tape and 1/8 inch strong cord
must be used to secure the tennis ball. Tennis balls that are overly 
firm may need to be punctured after
mounting.

The last sentence states that Tennis Balls being used as combat blunts 
if overly firm may need to be punctured after mounting.

The question - there is no instructions on how much of a puncture this 
should be. In other words, does the individual just take a ice pick and 
poke a hole in the ball, or does this puncture required to be larger?
  </pre>
</blockquote>
There is no instructions on "how much"  because that may be zero.  A
puncture is not required and if one is, then it needs to be just
enough.  Yeah an ice pick might be fine or ya may need a 1/4" drill bit.<br>
<br>
<blockquote cite="mid4502DC6A.4020305@netzero.net" type="cite">
  <pre wrap="">Whereas, the instructions are clear in:
Section D Slings:

1. Sling Stones – Shall be tennis balls wrapped in duct tape and with a 
small cut in the wall of the tennis ball in
order to collapse when stepped on. The cut shall be just large enough, 
approximately 1/2-inch (12.5mm) to
allow air out but not so large as to allow rocks, dirt and other debris in.
  </pre>
</blockquote>
<br>
That is clear but it WRONG.  That needs to be corrected as it
contradicts SCA rules.  The SCA rules say:<br>
"<i>The balls may be perforated with a 1/4 inch maximum diameter hole
by drilling. To prevent their collapsing when<br>
stepped on, they may not be slotted.</i>"<br>
<br>
So our instructions for sling stones in in violation of SCA rules and
needs to be updated.  No slots/cuts and only 1/4".<br>
<br>
-EA<br>
<br>
<br>
</body>
</html>