SC - On deep frying (WAS A couple of questions...
Gerekr at aol.com
Gerekr at aol.com
Thu Sep 7 13:17:06 PDT 2000
On 9/5/00 7:50 PM sca-cooks at ansteorra.org wrote:
>You don't mention what you are using to fry. I use a heavy pot with oil
>on a gas burner. Good heat control, and no more than half full of oil no
>matter what (avoid spillage). If using an auto-fry-thingy like a
>FryDaddy(tm), then I got no help for you. They're wild in terms of temp
>control. remember that oil drops in temp when you add food based on temp
>of food and amount of food added. Don't crowd, and keep food room temp so
>you can get oil back to desired temp quickly. Hope some of this helps.
>
>niccolo difrancesco
We use a cast iron footed pot, set up on a Wok ring, on our (best)
regular, 30-yr old electric stove-top burner. The pot profile pinches in
about an inch at the top... it's quite round, about 12" diameter both
high and wide.
Two of the large (2 qt?) bottles of oil fill our pot up to about a third.
Half is way too much to deal with, what with the bubble-up (our most
frequent item is home fish-n-chips... the water on the fries... woo ha!
Remember, with fries, the more thoroughly you drain the rinse water, the
better -- The less water on the surface, going into hot oil, the better.)
Fresh new oil will do the "bubble-up" worse, we've found.
The temp drop when food is added ... we try to gauge amounts added so
that we don't lose temp to below about 330 (when starting to add at ca.
380, for fries) Otherwise the food doesn't cook properly (and
consequently absorbs excess oil) because the oil has cooled too much.
Some things need two cookings, with temp coming all the way back up
before the 2d go.
The wok wire scooper thing-y, or a mesh spatter-screen, can be handy in
knocking down the bubble-up, if needed. If you're experiencing
bubble-up, slow down, and like Nicolo said, reduce the volume of what
you're putting in!
We use the 400 degree thermometers too... we use a piece of bent wire to
suspend the therm. in the oil without touching the bottom (!). Due to
the reverse flair at the pot mouth, we hang the wire off the the heavy
bail (handle) of the pot, over the edge. Hope that makes sense...
These tips gathered from ca. 18 yrs of figuring out how to do decent
fish-n-chips at home, because until quite recently the nearest good ones
were a nine-hour drive away! We now have one acceptable place in town,
and my husband's home-made still compare favorably, depending on who's
cooking at the restaurant; and the price differential, even at $7+/# for
halibut, is ridiculous.
Have fun. Be careful! Unlimber your kitchen fire extinguisher and/or
box of baking soda, if you're just starting (I'm still timid after all
these years, because my husband is the fryer, 8-)).
Chimene
More information about the Sca-cooks
mailing list