[Ansteorra-archery] Re: [fray-ansteorra] [Fwd: Golf Tube APD]
Duke, Wes
WDuke at aegonusa.com
Wed Jan 2 07:51:06 PST 2002
What is Playchoya said is exactly correct, a table saw works the best for
cutting and if possible use a drill press to drill the holes in the UHMW.
Fearghus
-----Original Message-----
From: Harry Bilings [SMTP:humble_archer at hotmail.com]
Sent: Friday, December 28, 2001 9:37 PM
To: ansteorra-archery at ansteorra.org
Subject: Re: [Ansteorra-archery] Re: [fray-ansteorra] [Fwd:
Golf Tube APD]
You can cut UHMW with a power saw (table or "skill") use standared
saftey
procidures. A table saw would be best. You could also cut the
fiberglass rod
yourself just wear a dust mask use a hacksaw or a copping saw the
hacksaw
has better blade life.
plachoya
>From: Mike <meggiddo at netzero.net>
>Reply-To: ansteorra-archery at ansteorra.org
>To: ansteorra-archery at ansteorra.org
>Subject: Re: [Ansteorra-archery] Re: [fray-ansteorra] [Fwd: Golf
Tube APD]
>Date: Fri, 28 Dec 2001 18:07:39 -0600
>
>Thanks Fearghus for the information.
>
>I did not consider that they would be cutting multiple rods at
once,
>that makes the sense now.
>
>I will need to contact the others and let them know about this
>information.
>
>Another question - how are you cutting the UHMW rod? I have thought
>about using a saw. Then someone suggested what is called a "hot
knife"
>which heats to 1100 degrees.
>
>Michael of the Fray
>
_________________________________________________________________
Send and receive Hotmail on your mobile device:
http://mobile.msn.com
_______________________________________________
Ansteorra-archery mailing list
Ansteorra-archery at ansteorra.org
http://www.ansteorra.org/mailman/listinfo/ansteorra-archery
More information about the Ansteorra-archery
mailing list